GX-60C AMPLIFIER
OWNER’S MANUAL
Congratulations!
You are now the proud owner of the versatile and powerful Crate GX-60C
amplifier with Stereo Chorus. With two flexible channels, Crate’s patented “Flex
Wave” distortion circuitry, a Stereo Effects Loop and three footswitchable func-
tions, the GX-60C offers you more flexibility and performance than any amplifier
in its class.
Like all Crate products, your GX-60C is Musician Made in the U.S.A., using
only the best components. Extensive testing at the hands (and ears) of skilled
technicians and musicians insures you that this amplifier is the absolute best it
can be.
In order to get the most out of your new amplifier, we strongly urge you to go
over the information contained in this manual before you begin playing.
And thank you for choosing
GX-60C Amplifier
AC LINE IN
SERIES EXT. SPEAKER OUTPUTS
30 WATTS MAX.
STEREO
HEADPHONES
STEREO
EFFECTS LOOP
FOOTSWITCH
JACKS
PER CHANNEL
MODEL: GX-60C
SERIAL: GX60C00-UR-MOOD
RISK OF ELECTRIC SHOCK
DO NOT OPEN
LINE: 120
V
~
60
Hz
RIGHT
(DRY)
LEFT
(CHORUS)
RISQUE DE CHOC ELECTRIQUE. NE PAS OUVRIR.
CHORUS
CHANNEL
SHAPE
/
AVIS:
WATTS: 100
MAX
RETURN
SEND
WARNING:
TO REDUCE THE RISK OF FIRE OR ELECTRIC
SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.
22
23
24
25
26
27
28
29
REAR PANEL:
22: AC LINE IN: This heavy-duty, grounded, three-wire 28: CHORUS FOOTSWITCH: Plug a single footswitch
power cord is to be plugged into ONLY a safely-wired, (such as the Crate CFP-1 or the “mono” plug of the Crate
grounded 120 volt, 60 cycle AC power outlet. DO NOT CFP-3) here to control the Chorus/Expander. The
attempt to defeat the ground connection of this cable! If footswitch overrides the front panel on/off switch (#16);
your GX-60C was purchased outside of the United States, selection between the Chorus and the Expander is still
see the unit’s rear panel for its power rating and follow the controlled by the front panel selector switch (#17).
above guidelines.
29: CHANNEL/SHAPE FOOTSWITCH: Plug a dual
23,24: EXT. SPEAKERS: You may connect the outputs of footswitch (such as the Crate CFP-2 or the “stereo” plug of
the GX-60C to your external speakers using these jacks. the Crate CFP-3) here to control Channel Selection and
When connecting speakers use a matched pair; that is, the Shape Active button. The footswitch overrides the front
two speakers with the same impedance to insure optimum panel switches (#4 and 8) and is wired as follows:
performance from the amplifier. Since these are series
Ring = Shape
connections to the internal speakers there is no chance of
Tip = Channels
Sleeve = ground
damaging the amplifier with too small of an impedance
load. The left speaker jack (#24) carries the chorus signal
(when the chorus is on) while the right jack (#23) is “dry”
(without the chorus effect).
Connecting to the Insert jack:
The Insert jack (#15) lets you patch external effects into the
amplifier just prior to its power amp stage. Use Crate’s
CYC6MS stereo-to-mono Y-cord or an adapter such as
Crate’s CA11Y and 2 1/4” mono signal cables to connect
to the effect as shown below.
WARNING: DO NOT attempt to use headphones in the
Speaker jacks! Permanent hearing damage could result!
25: STEREO HEADPHONES: Plug a pair of stereo head-
phones here for private listening. When this jack is used
the internal speakers and the external speaker jacks are
disconnected.
Stereo-to-mono Y-cord:
Y-adapter and 2 cables:
TIP
RETURN
TIP
to Insert
to Insert
jack
RING
SEND
RING
jack
26,27: STEREO EFFECTS LOOP: Connect the Send
jack (#27) to the input of your stereo effects device to send
a post-EQ, pre-chorus, pre-amplified signal for processing.
Connect the outputs of the effects device to the effects
Return jack (#26) to return the processed signal to the
amplifier. These jacks are stereo 1/4” phone jacks, wired
as follows:
SLEEVE
GROUND
SLEEVE
(STP201, 3'
STP202, 6'
STP203, 9')
(YPP117)
Ring = right channel
Tip = left channel
Sleeve = ground
(1/4"-TO-1/4"
MONO SHIELDED
CABLES)
If your effects device has stereo input and output jacks,
use a pair of three-conductor stereo patch cords to con-
nect to it. If the device has separate left and right jacks, use
a pair of one-stereo-male to two-mono-female Y-adapters
to make the connections, as shown to the right.
to
to
effect
"IN"
to
to
effect
"IN"
effect
"OUT"
jack
effect
"OUT"
jack
jack
jack
External Effect
External Effect
GX-60C Amplifier
GX-60C TECHNICAL SPECIFICATIONS
Output Power Rating
30 watts per channel RMS @ 5% THD 4 ohms
Speaker Size and Rating
Input Impedance
Crate Special Design 10” 50 watt (2)
470k ohms
Maximum Input Signal Level Accepted
Total System Gain
2.5 volts, peak-to-peak
Lead Channel: 107dB all controls @ 10, Shape active; 87dB Shape inactive
Rhythm Channel: 56dB all controls @ 10, Bright off
Channel A:
Channel B:
Low Control
Shape Control
High Control
10dB Range @ 80Hz
Proprietary Circuit
10dB Range @ 7kHz
Low Control
Mid Control
High Control
20dB Range @ 100Hz
14dB Range @ 700Hz
27dB Range @ 10kHz
Input Power Requirements
120 VAC, 60Hz, 80VA
100/115VAC, 50/60Hz, 80VA
230VAC, 50/60Hz, 80VA
Cabinet Size and Weight
18-1/4” H x 23” W x 10-1/2” D, 55 lbs.
The GX-60C is covered with a durable black Tolex material: wipe it
clean with a lint-free cloth. Never spray cleaning agents onto the
cabinet. Avoid abrasive cleansers which could damage the finish.
CAUTION
ATTENTION
VORSICHT
RISK OF ELECTRIC SHOCK
DO NOT OPEN
RISQUE D'ELECTROCUTION
NE PAS OUVRIR
ELEKTRISCHE SCHLAGGEFAHR
NICHT OFFENEN
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK,
DO NOT REMOVE COVER.
ATTENTION: POUR REDUIRE D'ELECTROCUTION NE PAS
ENLEVER LE COUVERCLE. AUCUNE PIECE INTERNE N'EST REPRABLE
PAR L'UTILISATEUR. POUR TOUTE REPARATION, S'ADRESSER A UN
TECHNICIEN QUALIFIE.
VORSICHT: ZUR MINIMIERUNG ELEKTRISCHER SCHLAGGEFAHR NICHT
DEN DECKEL ABENHMEN. INTERNE TEILE KONNEN NICHT VOM
BENUTZER GEWARTET WERDEN. DIE WARTUNG IS QUALIFIZIERTEM
WARTUNGSPERSONAL ZU UBERLASSEN.
NO USER-SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
THIS EQUIPMENT HAS BEEN DESIGNED AND ENGINEERED TO PROVIDE SAFE AND RELIABLE OPERATION. IN ORDER TO PROLONG THE LIFE OF THE
UNIT AND PREVENT ACCIDENTAL DAMAGES OR INJURY, PLEASE FOLLOW THESE PRECAUTIONARY GUIDELINES:
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT OPEN CHASSIS; DO NOT DEFEAT OR REMOVE THE GROUND PIN OF THE POWER
CORD; CONNECT ONLY TO A PROPERLY GROUNDED AC POWER OUTLET.
WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS EQUIPMENT TO RAIN OR MOISTURE.
CAUTION: NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
CAUTION: OUR AMPLIFIERS ARE CAPABLE OF PRODUCING HIGH SOUND PRESSURE LEVELS. CONTINUED EXPOSURE TO HIGH SOUND PRESSURE
LEVELS CAN CAUSE PERMANENT HEARING IMPAIRMENT OR LOSS. USER CAUTION IS ADVISED AND EAR PROTECTION IS RECOMMENDED IF UNIT IS
OPERATED AT HIGH VOLUME.
EXPLANATION OF GRAPHICAL SYMBOLS:
EXPLICACION DE SIMBOLOS GRAFICOS:
EXPLICATION DES SYMBÔLES GRAPHIQUES:
"IT IS NECESSARY FOR THE USER TO REFER TO THE INSTRUCTION MANUAL"
“ES NECESARIO QUE EL USUARIO SE REFIERA AL MANUAL DE INSTRUCCIONES.”
"REFERREZ-VOUS AU MANUAL D'UTILISATION"
"DANGEROUS VOLTAGE"
“VOLTAJE PELIGROSO”
"DANGER HAUTE TENSION"
"GEFAHLICHE SPANNUNG"
=
=
"UNBEDINGT IN DER BEDIENUNGSANLEITUNG NACHSCHLAGEN"
Crate continually develops new products, as well as improves existing ones. For this reason, the
specifications and information in this Crate manual are subject to change without notice.
©1997 SLM ELECTRONICS, A DIVISION OF ST. LOUIS MUSIC, 1400 FERGUSON, ST. LOUIS, MO. 63133
P/N 47-473-01 • 03/97
|